Garage Door Closing By Pressing Button Continously

The locking feature is meant to prevent garage door remotes from opening your door.

Garage door closing by pressing button continously. Tuesday june 26 2018. However the two most common reasons include a problem with the lock button and malfunctioning safety reversing sensors. If you own a new garage door opener that comes with a locking feature it s possible someone may have accidentally locked your garage door by pressing the lock button. Having your garage door light blink continuously is not only annoying it s also a sign that there is something wrong with the mechanism.

Only the button on the wall control or manual keypad inputs will open it. If you try to open your door using a remote while the lock system is engaged you ll notice that the garage door light will begin blinking continuously. If pressing the button on your garage door s remote control doesn t work check the batteries first. These garage door safety sensors are located close to the ground and are responsive to any potential obstructions.

Clicking sounds from the garage door opener may also be caused by issues with the photosensors. The symptom of this is a garage door that is in constant motion opening fully then immediately descending only to start the same cycle again. Any transmitter like a handheld clicker or outdoor keypad will also not work to close the door if there is a problem with the sensor. If it is old or dirty the button may stick.

It all depends on the configuration but you likely have a button that activates the door operator. The button can easily get dirty and stuck in the pushed. There are several reasons why your garage door opener is doing this. If the wires appear to be in good shape next look at the control button mounted near your side entry door.

The door operator button is similar to a door bell. To troubleshoot the garage door opener button make sure it s clean and free of debris. Examine the garage door opener button.